,

NEMICON Rotary Encoder SBH2-1024-2T (1024P/R)

• Manufacturer — NEMICON
• Model Number — SBH2-1024-2T
• Voltage (Min) — NA
• Voltage (Max) — 12V
• Current (A)v30m
• Temperature Range (Min) — -10°C
• Temperature Range (Max) — 70°C
• Step Per Revolution(Min) — NA
• Step Per Revolution(Max) — 4 5,000rpm
• Torque — 0.01N.m
• Size (mm) — NA

 15,200.0

Compare

NEMICON Rotary Encoder SBH2-1024-2T 1024 P/R

Output phase A, B, Z phase(Line driver output : A, A, B, B, Z, Z phase)
NPN open collector output Load current : Max. 30mA, Residual voltage : Max. 0.4VDC
Voltage output Load current : Max. 10mA, Residual voltage : Max. 0.4VDC
Line driver output
Low Load current: Max. 20mA, Residual voltage : Max. 0.5VDC
High Load current: Max. -20mA, Output voltage(Power voltage 5VDC): Min. 2.5VDC,
Moment of inertia Max. 80g.cm2(8×10-6kg.m2)2, Max. 400g.cm2(4×10-5kg.m2)3 Max. 40g.cm2(4×10-6kg.m2)
Shaft loading Radial: Max. 10kg.f, Thrust: Max. 2.5kg.f Radial: Max. 2kg.f, Thrust: 1kg.f

This unit consists of precision components. If you drop this unit, it may lose the function.Please treat this product carefully when you install this unit, if eccentricity and deflection angle are larger, load is applied to the shaft. It may shorten the life cycle of this unit.Do not put strong impact with hammer, etc when insert coupling into shaft.

1. For using

Please use attached Sil Twist pair wire and use proper receiver for RS-422A communication.Do not cut or connect circuit when power is ON. It may cause damage to the unit.When the power source is Switching Power, it may cause surge. Install a surge absorber in power line. Wire should be shorter in order not to be influenced by noise.

2. Environment

Please do not use this unit with below environment, or it may cause malfunction.Place where this unit or component may be damaged by strong vibration or impact.

Place where there is a lot of flammable or corrosive gases.Place where strong magnet field or electric noise occurs.

3. Vibration and Impact

If a big impact or strong vibration applies to the product it may cause pulse errors. Be sure that when installing this unit. Encoder with high resolution can be easily affected by vibration, therefore tighten fixing bracket.

4. Wire connection

Do not pull out the wire with over 30N strength after fixing the unit and wiring the cable.If wire encoder cable with high voltage line or power cable in the same conduit, it may cause a malfunction or mechanical problem. Please wire it separately or use separated conduit.

Manufacturing sites
Motion/Servo Control
Various business machine control fields.
Automated production lines

SKU: MOT-0016 Categories: , Tags: ,